Note I am not powering the Tuxedo from the panel. MCU Firmware 1.11Ģ) Vista 20P panel purchased new, running firmware 10.23ģ) Enabled all four AUI devices via *189 programming option for partition 1Ĥ) Enabled keypads via programming options *190 thru *193ĥ) Verified wiring and power. This is the scenario:ġ) Tuxedo Touch purchased used, running software version TUXW_V5.1.13.0. I'm begging to think it may be the firmware or even the Tuxedo Touch itself as the problem. I can not get past ECP errors no matter what address 1,2,5 or 6 that are available.
I have a used Tuxedo Touch WiFi model I am trying to install on a Vista 20P panel. All I needed to do was jumper the (-) NEG wire from the power supply to the GND on the panel. FIXED: So, if you read the instructions carefully, you usually find a solution.
0 kommentar(er)
